Architecture · 5 February 2026 · 8 min read
Architectural detailing with metal

Metal is unforgiving in a way that rewards good detailing. Three moves account for most of the difference between crisp and cheap.
The return
A panel that folds back at its edge reads as solid. A flat panel with a visible cut edge reads as a skin.
A 25 mm return is usually enough to change the perception entirely.
Metal does not forgive an undecided edge.
The shadow gap
Butt joints show every tolerance. A consistent shadow gap absorbs deviation and turns the joint into a line.
Set the gap once and hold it across the whole surface, including at corners.
The grain direction
Directional finishes need a stated grain on the drawings, including for returns and reveals.
Where two grains meet, decide deliberately whether they align or deliberately oppose.
- Return
- 25 mm minimum
- Shadow gap
- Consistent, corners included
- Grain
- Stated on drawing
Return the edge, hold the gap, state the grain. Those three notes on a drawing raise the result more than any change of finish.


